Products
Repellent for dogs - RC-01
Supply Voltage: 90V - 240V (dual voltage auto)
Power: 1W
Power consumption: 0.001 Kw / h
Operating Frequency: 20-30 kHz adjustable
Emitting activities area: opens a cone of 120 ° (horizontal) and 90 ° (vertical) and reaches approximately 10m in a straight line.
Sensitivity: 92dB + or - 3 dB / W 10cm
Operating Temperature: -20 ° / +60 °
Switching power supply: 12V DC 1A.
Cable to connect power supply to the transmitter block: 5m long
The Shoo Dogs - Dog Repellent was developed to repel dogs from desired locations without abusing animals.
Instructions for use:
The appliance must not be installed behind obstacles;
The source must be sheltered from moisture, the transmitter module can be installed in time;
This must remain on uninterrupted.
Install the unit at an approximate height of the dog (with set screws) directed to sites where you want to repel the dog.
Connect the power supply plug;
Connect power supply to the network and check that the lamp is lit;
Check the appliance through the green LED flashing and the "Sensor Test" on the side. Place the sensitive area is the yellow circle. Approaching the imam of the sensitive area will trigger the sensor test. Sensor test transforms the sound waves audible to the human ear to check the appliance. It is forbidden to approach the ear of the emitters when the test performed to avoid possible damage to the auditory system.
To adjust frequency at the bottom of the device, use the key philips, which is supplied with the appliance, turning clockwise to decrease frequency and anti-clockwise to increase frequency, adjusting to best effect in relation to the dog.
We advise not to change the tuning frequency of the factory to check